Position: Home » Product Wiki » Rail Tamping Machine Safety Operating Procedure
Rail Tamping Machine Safety Operating Procedure
1. Check whether the horizontal rail tamping machine is laid flat and fixed firmly. The rail saw rail and the track are properly engaged.
2. Before use, check and confirm that the rail tamping machine motor, cable, protective earthing and protection devices are safe and effective, the saw blade is suitable and installed correctly.
3, check the rail tamping machine work surface, lubrication system, cooling system, electronic control system, vertical lifting system, lateral movement system, brake device is normal and effective.
4. Open the rail tamping machine inlet pipe, and the normal water flow will be sprayed from the side of the saw blade to the saw disk and rock.
5. After starting the rail tamping machine motor, it should run at no load, confirm that the saw blade is running in the correct direction, the lifting mechanism is flexible, the equipment is running without abnormality and no abnormal noise, and the saw blade can be rotated before it can be cut.
6, rail tamping machine cutting process to observe whether the operating conditions are normal, each meter indicates stable, cutting with a crisp "sand" sound, the machine runs without abnormalities, no abnormal noise, no carding phenomenon.
7. When the impact of the rail tamping machine is abnormal, such as impact, runout or abnormal sound, stop the inspection immediately and continue the operation after troubleshooting.
8. The temperature of the bearing part rises no more than 40 °C after the spindle housing is operated for 2 hours.
9, rail tamping machine saw blade and swarf debris should be removed in time with special tools, not pick and pick by hand.
10. It is strictly forbidden to repair and replace parts during the operation of the rail tamping machine.
11. It is not allowed to replace the saw blade with crack damage and the fixed shaft and the saw blade hole are not well matched.
12. Remove the saw blade and confirm that the sling and hook are safe to ensure that the two are present.
13. After the operation stops, the machine body should be cleaned, the saw blade should be dried, the water tank water should be drained, and the cable should be stored in a dry and ventilated place.
2. Before use, check and confirm that the rail tamping machine motor, cable, protective earthing and protection devices are safe and effective, the saw blade is suitable and installed correctly.
3, check the rail tamping machine work surface, lubrication system, cooling system, electronic control system, vertical lifting system, lateral movement system, brake device is normal and effective.
4. Open the rail tamping machine inlet pipe, and the normal water flow will be sprayed from the side of the saw blade to the saw disk and rock.
5. After starting the rail tamping machine motor, it should run at no load, confirm that the saw blade is running in the correct direction, the lifting mechanism is flexible, the equipment is running without abnormality and no abnormal noise, and the saw blade can be rotated before it can be cut.
6, rail tamping machine cutting process to observe whether the operating conditions are normal, each meter indicates stable, cutting with a crisp "sand" sound, the machine runs without abnormalities, no abnormal noise, no carding phenomenon.
7. When the impact of the rail tamping machine is abnormal, such as impact, runout or abnormal sound, stop the inspection immediately and continue the operation after troubleshooting.
8. The temperature of the bearing part rises no more than 40 °C after the spindle housing is operated for 2 hours.
9, rail tamping machine saw blade and swarf debris should be removed in time with special tools, not pick and pick by hand.
10. It is strictly forbidden to repair and replace parts during the operation of the rail tamping machine.
11. It is not allowed to replace the saw blade with crack damage and the fixed shaft and the saw blade hole are not well matched.
12. Remove the saw blade and confirm that the sling and hook are safe to ensure that the two are present.
13. After the operation stops, the machine body should be cleaned, the saw blade should be dried, the water tank water should be drained, and the cable should be stored in a dry and ventilated place.
14. It is strictly forbidden to go to work after drinking.
